Tapping signal taps shows IN on every bus. Could this be changed to show the applied configuration?
Mixer Model: MR18
App Version: 1.0.0 (71)
Tapping signal taps shows IN on every bus. Could this be changed to show the applied configuration?
Mixer Model: MR18
App Version: 1.0.0 (71)
Tablets are connected. Bus 1-4 are pre fader using globing bus config but global bus config shows IN for all busses.
Global bus config? Are you sure you're not looking at the output master config? That part of Behringer's setup confuses many people. What do you see from X Air Edit on a laptop?
The global bus config is a feature of the app, the mixer does not have this state. Therefore the default selection is always "In". This popup is not an indicator, only an editor